Location Of Controls; Before Using For The First Time - Buffalo DN487 Mode D'emploi

UK
Operation

Location of Controls

Warning indicator
(red light)
Brewing Indicator
(green light)
Stainless Steel Jug

Before Using for the First Time

BUFFALO recommend that the appliance is cleaned out before using for the first time, or if the appliance
has been sat unused for an extended period of time.
Fill the water reservoir with cold water.
1.
Note: Use the jug to fill the reservoir to ensure the maximum capacity of the jug is not
exceeded. The maximum amount of water the reservoir can contain is 2.2 litres.
Do not overfill the water reservoir. If too much water is filled, excess water will drain
out through the overflow pipe.
Slide the empty filter basket into position between the two basket tabs.
2.
Place the jug on the base beneath the basket.
3.
Turn the power switch On . The Brewing Indicator lights up and hot water will begin to fill the jug.
4.
Note: During operation, steam may rise from the appliance and loud bubbling noises
may be heard. This is perfectly normal.
Once finished the Brewing Indicator light will switch off. Discard the hot water in the jug.
5.
WARNING: The jug becomes hot during operation. Always pick up the jug by the handle
to avoid injury.
Repeat steps 1-5. The appliance is now clean.
6.
2
Water reservoir
inlet
On / Off Switch
with indicator
Filter basket
Overflow pipe
Jug Lid