Fagor VCE-306 Manuel D'utilisation page 13

interior 14/5/04
• Always unplug the appliance before
changing filters or cleaning or when you
have finished using it.
• Do not use the vacuum cleaner outside or
on wet surfaces. Do not vacuum wet or
damp dust or dirt particles.
• Do not vacuum flammable liquids such as
cleaning fluids or petrol, etc., or their
fumes.
• Do not vacuum hard, sharp or oversized
objects, matches, hot ashes, cigarette
ends or any other such materials.
• Do not let children or the mentally disabled
use the appliance.
4. ASSEMBLING AND USING
FOR THE FIRST TIME
1
16:01 Página 11
1
2
2
• Do not leave the appliance near hot
ovens, heaters or radiators.
• Do not move the appliance by pulling on
the cable or flexible tube. Use the
transport handle provided.
• Never use the vacuum cleaner without its
filters.
• Change filters after vacuuming fine dust
particles or cleaning new rugs or carpets.
• Do not vacuum very fine particles such as
cement, fine sand or flour, etc.
• Do not use the appliance if the suction
channels are obstructed in any way, since
this could cause the motor to overheat.
To extend the telescopic tube (14) to the length
you require, push the catch forward. Next, attach
the brush (11) or one of the nozzles (17) or (18) to
one end of the tube and insert the flexible tube
(12) into the other.
Insert the flexible tube into the suction inlet (1),
making sure the grooves coincide with their
corresponding ridges to ensure a secure fit. To
release, simply press the fluted wings on the
flexible tube and pull.
Pull the connection cable (19) to unwind it from its
housing and plug into the mains.
Warning: The end of the cable is indicated by a
yellow mark. Do not continue to pull on the cable
after this yellow mark has appeared, as this could
cause irreparable damage to the cable winding
device.
Press the start-stop pedal (6) to switch the vacuum
cleaner on. To switch off, simply press the pedal once
again. Before switching the vacuum cleaner on, use
the electronic power regulator (8) to turn the power
setting to minimum, and then gradually increase to
the desired setting after the motor has started up.
12