Hama 00123395 Mode D'emploi page 5

6. Operation
6.1 HF connection
• Connect the input of the ampli er to the building
interconnection point. Connect the output of the
ampli er to the antenna sockets or splitters used.
• For this purpose, use well shielded coaxial cables.
Suitable accessories can be found at www.hama.com
6.2 Attenuation (G.C.) and equalisation (S.C.)
settings
• The G.C. and S.C. controls are used to set attenuation
and equalisation.
• The LED display shows the ampli cation level.
Note
To ensure optimum ampli cation, it is recommended
that you use an antenna measuring device.
7. Care and Maintenance
• Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
10. Technical Data
Frequency range
Gain
Output level
Gain control
Power supply unit
Impedance
11. Recycling Information
Note on environmental protection:
After the implementation of the European
Directive 2012/19/EU and 2006/66/EU in the
national legal system, the following applies:
Electric and electronic devices as well as
batteries must not be disposed of with household waste.
Consumers are obliged by law to return electrical and
electronic devices as well as batteries at the end of their
service lives to the public collecting points set up for this
purpose or point of sale. Details to this are de ned by the
national law of the respective country. This symbol on the
product, the instruction manual or the package indicates
that a product is subject to these regulations. By
recycling, reusing the materials or other forms of utilising
old devices/batteries, you are making an important
contribution to protecting our environment.
86–862 MHz
30 dB
112 dBµV
-18 dB~0 dB (1)
230 V ~ 50 Hz 5 W
75
3