2.4 GHz Pocket Transmitter
These instructions are intended for users without
any specific technical knowledge . Please read
these instructions carefully prior to operating the
unit and keep them for later reference .
All operating elements and connections
described can be found on the fold-out page 3 .
1 Operating Elements and
Connections
1.1 Pocket Transmitter
1 Connection jack for one of the microphones
2 On / off switch; in mid-position, the micro-
phone is muted
3 Power LED
– lights up during operation
– starts flashing when the batteries are low
and while the units are being matched
4 Volume control
5 Belt clip
6 Cover of battery compartment
7 Selector switch for the transmission channel
8 Momentary pushbutton RESET to match the
transmitter and the rceiver (to establish a
new wireless connection)
9 Batteries in the battery compartment
1.2 Microphones
10 Headband microphone
11 Tie clip microphone
12 Clip
13 Locking plug of the headband microphone,
3 .5 mm plug
14 Locking plug of the tie clip microphone,
3 .5 mm plug
2 Important Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
•
The unit is suitable for indoor use only . Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambi-
ent temperature range 0 – 40 °C) .
•
For cleaning only use a dry, soft cloth; never
use water or chemicals .
•
No guarantee claims for the unit and no liabil-
ity for any resulting personal damage or mate-
rial damage will be accepted if the unit is used
for other purposes than originally intended, if
it is not correctly connected or operated, or if
it is not repaired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harm-
ful to the environment .
3 Applications
This set combines a pocket transmitter, a head-
band microphone and a tie clip microphone and
is used to extend the wireless microphone sys-
tem TXS-2402SET . The digital transmission with
high resistance to interference is made on one
of 16 channels available in the 2 .4 GHz range .
Alternatively connect the microphones to the
pocket transmitter . This is ideally suited for any
hands-free applications .
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare
that the unit TXS-2401SX is in accordance with
the basic requirements and the other relevant
regulations of the directive 2014 / 53 / EU . The
declaration of conformity can be requested from
MONACOR INTERNATIONAL . The pocket trans-
mitter operates in the 2 .4 GHz range . It is licence-
free and generally approved for operation in EU
and EFTA countries .
.
7