Handlebar Switches - Yamaha Kodiak YFM450FAV Manuel Du Propriétaire

1. Light switch " / /OFF"
2. Start switch " "
3. Engine stop switch "
4. Override switch "OVERRIDE"
5. Horn switch " "
1. Contacteur d'éclairage "
2. Contacteur du démarreur "
3. Coupe-circuit du moteur "
4. Contacteur de désactivation "OVERRIDE"
5. Contacteur de l'avertisseur "
1. Interruptor de las luces "
2. Interruptor de arranque "
3. Interruptor de paro del motor "
4. Interruptor de cancelación "OVERRIDE"
5. Interruptor de la bocina "
/ "
/ /OFF"
"
/ "
"
/ /OFF"
"
/ "
"

Handlebar switches

Light switch "
Set the switch to "
the taillight.
Set the switch to "
and the taillight.
Set the switch to "OFF" to turn off all the lights.
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it.
_
Engine stop switch "
Make sure that the engine stop switch is set to
" " before starting the engine. The engine stop
switch controls ignition and can be used at all
times to stop the engine, especially in an emer-
gency. The engine will not start or run when the
engine stop switch is set to "
4-17
/ /OFF"
" to turn on the low beam and
" to turn on the high beam
/ "
".
EBU00053
EBU12040
EBU12050