HIKOKI N 14DSL Mode D'emploi page 23

TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the HiKOKI Authorized Service Center.
Symptom
Tool The stapler won't fi re
staples.
Staples are not fully driven
in.
Blank fi ring.
Possible cause
The battery has run out of power.
The battery has not been attached
correctly.
The trigger was released halfway
through being pulled in the single-
shot mode.
Power tool abnormalities.
The material is too hard.
The stapler is recoiling.
The driver blade is worn down.
The anti-blank fi ring mechanism is
not working.
Staples are jammed nearby the
discharge outlet.
The driver blade is worn down.
Feeder operations are sluggish.
23
Remedy
Recharge the battery with the
recharger.
Remove the battery and check to
see if foreign matter exists in the
stapler's battery insertion bed. Also
check to make sure that the battery
terminals are not soiled.
Press down on the battery until it
clicks into place.
Remove the battery from the stapler,
and then replace it.
Contact your dealer or the HiKOKI
Authorized Service Center.
There are cases in which hard
materials cannot be stapled correctly.
The discharge outlet is not being
pressed fi rmly enough against the
area where the staple is to be drive.
Contact your dealer or the HiKOKI
Authorized Service Center.
Clean all dirt or foreign matter from
around the micro switch inside the
magazine.
Clean all jammed staples or dirt, etc.
Contact your dealer or the HiKOKI
Authorized Service Center.
Clean all dirt or foreign matter from
the inside of the magazine.
English