Baninni VENTURA BNCS008 Mode D'emploi page 14

MANUAL
3.2-3.6 Removing the harness:
3.2 Remove the end piece (1):
Push the central adjuster (2) down, keep
it down and remover the belt from the rear.
3.3 Pull the shoulder straps out through the front.
3.4 Remove the guiding tube by pushing it
upwards. Then remove the shoulder belts.
3.5 Partly remove the seat cover and unloop
the lap belt from the seat body.
3.2-3.6 Removing the harness:
3.2 Remove the end piece (1):
3.3 Pull the shoulder straps out through
the front.
3.4 Remove the guiding tube by pushing
it upwards. Then remove the shoulder
belts.
3.5 Partly remove the seat cover and
unloop the lap belt from the seat body.
3.6 Unloop the metal plate from the
button strap and pull the buckle up and out
4.1-4.3 Restrain the seat and child with
the 3-point seat belt.(Group II III - with
backrest)
4.1 Pull out the car belt, pass the shoulder
belt under the headrest at one side. And
the lap belt pass through the hole of both
armrests.Then pushing the buckle in
with an audible click.