Baninni VENTURA BNCS008 Mode D'emploi page 13

2.1 -2.6 Using the Harness
To increase the length of the
harness press and hold down the
central adjusting button (1) and pull
the shoulder straps (2) at the bottom
2.2Unfasten the buckle by pressing the
red button in the direction of the arrow
2.3 Lay the shoulder straps to the side.
2.4 Place your child in the seat and put
the child's arms through the shoulder straps.
2.5 Fasten the buckle by placing the two
tongues over each other (1) and pushing
them in with an audible click
2.6 Tighten the straps by pulling the central
belt in the direction of the arrow. The straps
should be pulled tight.
2.7-2.8 Adjusting the height of the harness
2.7 Pull the red locking button and adjust the
head support in the next position.
2.8 Use one hand to press down the central
adjusting button, and the other hand pull the
belt to adjust it to be suitable length.(2.6&2.8A).
The shoulder straps should be positioned as
shown in this diagram 2.8A
3.1 Removing the cover
The support cushion should be removed
depending on the size of the child, and
not later than when the harness is removed.
If the harness is still attached unhook the
shoulder straps as shown in diagram 3.3.
Unbutton the cover and remover the two
parts of the cover by lifting them forwards