Battery; Topping Up The Chain Oil Tank - Stiga PR 500 Li 48 Manuel D'utilisation

comply with these instructions to
avoid serious risks or dangers.
Before conducting any inspections,
cleaning or maintenance/adjustment
interventions on the machine:
• Stop the machine;
• Wait until the chain is stationary;
• Remove the battery from its housing;
• Apply the bar cover, except when working
directly on the chain or bar itself.
• Wait until the motor is sufficiently cold;
• Read the relevant instructions;
• Use suitable clothing, protective
gloves and goggles;
• The frequency and types of maintenance
are summarised in the "Maintenance
Table". This table will help you maintain
your machine's safety and performance.
It summarises the main interventions to
be made and the frequency applicable to
each of them. Carry out the relevant task as
soon as it is scheduled to be performed.
• The use of non-genuine and/or incorrectly
assembled spare parts and attachments
could adversely affect machine operation
and safety. The manufacturer shall
decline all liability in the event of injuries
or damages caused by such parts.
• Genuine spare parts are supplied by
authorised assistance workshops and dealers.
IMPORTANT Any maintenance and
adjustment operations not described in
this manual must be carried out by your
dealer or Authorised Service Centre.

7.2 BATTERY

7.2.1 Battery power reserve
Battery autonomy is mainly influenced by:
a. environmental factors, that cause
higher energy requirements:
– cutting trees and branches that are too thick;
b. operator behaviour that should be avoided:
– switching the machine on and off
frequently whilst working;
– adopting a cutting technique that
is unsuitable for the work to be
performed (par. 6.6, par. 6.7);
To optimise battery power reserve
it is always recommended to:
• cut wood when dry;
• use the most appropriate technique
for the work to be performed
If the need arises to use the machine for
sessions which exceed the capability of
a standard battery, it is possible to:
• purchase a second standard battery
to immediately replace the discharged
battery, without compromising
the continuity of operations;
7.2.2 Battery removal and recharging
1. Press the button placed on the battery
14.A) and remove it (Fig. 14.B);
2. Fit the battery (Fig. 33.A) in the battery
charger housing (Fig. 33.B);
3. Connect the battery charger to a mains
power socket (Fig. 33.C) with the
voltage indicated on the rating plate.
4. Fully charge the battery according
to the instructions in the battery/
battery charger booklet.
NOTE The battery is equipped with a guard
that inhibits recharging if the environmental
temperature is not between 0 and +45 °C.
NOTE The battery can be recharged at any
time, even partially, with no risk of damaging it.
7.2.3 Refitting the battery on the machine
When recharging is completed:
1. Remove the battery (Fig. 34.A) from the
housing in the battery charger (do not keep
charging when recharging is completed);
2. Disconnect the battery charger from
the electrical outlet (Fig. 34.B);
3. Fit the battery (Fig. 14.B) in its housing
pressing down until you hear it click firmly into
position which ensures the electrical contact;

7.3 TOPPING UP THE CHAIN OIL TANK

NOTE The following symbol is found
near the chain oil tank cap (fig. 35.A) :
Chain oil tank
IMPORTANT
oil or adhesive oil for chainsaws. Do
not use oil containing impurities so as
not to block the oil filter and to prevent
irreparable damage to the oil pump.
It is essential that you use good quality oil
to lubricate the cutting parts effectively.
Used or poor quality oil does not
EN - 14
Only use chainsaw