Makita GD0800C Manuel D'instructions page 6

Refer to the table for the relationship between the num-
ber settings on the dial and the approximate tool speed.
GD0800C
Number RPM
1 - 2 7,000 - 10,000
2 - 3
10,000 - 17,000
3 - 4 17,000 - 24,000
4 - 5 24,000 - 29,000
CAUTION:
• If the tool is operated continuously at low
speeds for a long time, the motor will get over-
loaded, resulting in tool malfunction.
• The speed adjusting dial can be turned only as
far as 5 and back to 1. Do not force it past 5 or
1, or the speed adjusting function may no longer
work.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing the side handle
1
► 1. Side handle
Always use the side handle to ensure operating safety.
Install the side handle on the tool barrel, then tighten
the handle by turning clockwise at the desired position.
Installing or removing wheel point
GD0810C
RPM
1,800 - 2,400
2,400 - 4,100
4,100 - 5,800
5,800 - 7,000
► 1. Wrench 19 2. Wrench 13 3. Collet nut
Loosen the collet nut and insert the wheel point into the
collet nut. Use the smaller wrench to hold the spindle
and the larger one to tighten the collet nut securely.
The wheel point should not be mounted more than 10
mm (3/8") from the collet nut. Exceeding this distance
could cause vibration or a broken shaft.
To remove the wheel point, follow the installation proce-
dure in reverse.
•
6 ENGLISH
1
10 mm (3/8") MAX.
CAUTION:
A 1/4" collet cone is provided as standard equip-
ment. Use an optional collet cone 1/8" to install
a 1/8" shank wheel point.
2
3