Metabo HPT CM 75EAP Instructions De Sécurité Et Mode D'emploi page 9

NOTE
Suffi cient power is not transmitted to the wheel
when the belt is loose. Appropriately adjust the
belt as necessary.
Adjustment of wheel guard
1. Wheel guard (14) can be moved by hand without
using a tool. To adjust the wheel guard (14), use
handle(W) (15), or press the end of wheel guard
(14) against the workpiece. (Fig. 14)
15
14
Make sure to adjust the wheel guard (14) to shield
you from any fl ying debris. (Fig. 15)
14
4
11
12
Fig. 12
12
11
13
Fig. 13
Fig. 14
Fig. 15
Wet cutting with water
This machine can be set up for wet cutting which can
suppress dust emission during cutting.
1. Remove coupler (16) by pulling the coupler from the
machine. (Fig. 16)
2. Remove the ring (17) from the coupler, slide the ring
over the hose and insert the hose to the coupler.
(Fig. 17)
3. Re-tighten the ring to the coupler securely.
4. Reattach the coupler to the machine until it locks
into position.
5. Running water into the hose, turn the lever (18) of
valve (19). (Fig. 18) This will supply to the cut-off
wheel.
Warning
The cut-off wheel that is included with this machine
is an abrasive cut-off wheel for concrete, stone, or
masonry.
When cutting with water supplied to this cut-off
wheel, use the wheel up on the same day. There
is a risk of bursting when using the abrasive wheel
wetted in this manner on the following day.
For other cut-off wheels, follow the instructions
provided with those cut-off wheels.
9
English
16
Fig. 16
17
Fig. 17
19
18
Fig. 18