Assembly Procedures - Tanaka TCH 22EPAP Instructions De Sécurité Et Mode D'emploi

ASSEMBLY PROCEDURES

Drive shaft to engine (Fig. 1)
Loosen tube locking bolt (1) about ten turns so that
the bolt point will not obstruct drive shaft tube to be
inserted. When inserting drive shaft tube, hold the
tube locking bolt outward preventing inside fi tting
from obstructing as well.
Insert the drive shaft into the clutch case of the
engine properly until the marked position (2) on the
drive shaft tube meets the clutch case.
1
2
NOTE
When it is hard to insert drive shaft up to the
marked position on the drive shaft tube, turn
drive shaft by the cutter mounting end clockwise
or counter-clockwise. Tighten tube locking bolt
lining up the hole in the shaft tube. Then tighten
clamp bolt securely.
Cutting attachment to drive shaft
(Fig. 2)
Loosen tube locking bolt (3).
Insert the drive shaft into the gear case of the
attachment properly until the marked position (4) on
the drive shaft tube meets the gear case.
5
4
NOTE
When it is hard to insert drive shaft up to the
marked position on the drive shaft tube, turn
attachment clockwise or counter-clockwise.
Tighten tube locking bolt lining up the hole in the
shaft tube. Then tighten clamp bolt (5) securely.
Installation of handle (Fig. 3)
Attach the handle to the drive shaft tube with the
angle towards the engine.
Fig. 1
3
Fig. 2
Adjust the location to the most comfortable position
before operation.
Throttle wire / stop cord
Press the upper tab (6) and open the air cleaner
cover. (Fig. 4)
Connect stop cords. (Fig. 5)
If the throttle outer end (7) is threaded on your unit,
screw it into the cable adjuster stay (8) all the way,
and then tighten this cable end using the adjuster
nut (9) against the cable adjuster stay (8).
Connect throttle wire end (10) to carburetor (11)
and install swivel cap (12) (if so equipped) where is
included in tool bag, onto swivel (11) (Fig. 6).
8
7
Some models may come with the parts installed.
English
Fig. 3
6
Fig. 4
Fig. 5
12
11
10
9
Fig. 6
7