Trimming Techniques; Maintenance - Tanaka TCH 22EPAP Instructions De Sécurité Et Mode D'emploi

English
WARNING
During operation, hold the unit fi rmly with both
hands. A single hand operation may cause
serious injury.
Adjustment of blade angle (Fig. 15, 16)
WARNING
Always stop engine before making adjustments.
Never touch the blade when adjusting blade
angle. Hold the support handle (17) instead.
1. Stop the engine.
2. Loosen handle knob (18) slightly so that the
support handle (17) slides.
3. Adjust the blade angle to desired position by
holding the support handle (17).
4. Then, fi nger-tighten the handle knob (18)
securely.
17

Trimming techniques

This unit is designed for trimming hedges and small
branches.
Follow these tips for successful operation.
○ Plan cut carefully. Check direction branch will
fall.
○ Long branches should be trimmed in several
pieces.
○ Do not stand directly beneath branch being cut.
○ Apply a light cutting pressure.
○ Ease cutting pressure when nearing end of cut
to maintain control.
10
18
Fig. 15
Fig. 16

MAINTENANCE

MAINTENANCE, REPLACEMENT OR REPAIR
OF THE EMISSION CONTROL DEVICES AND
SYSTEMS MAY BE PERFORMED BY ANY NON-
ROAD ENGINE REPAIR ESTABLISHMENT OR
INDIVIDUAL.
MAKE SURE THAT ALL MAINTENANCE IS
CARRIED OUT WITH THE ENGINE STOPPED AND
AFTER IT HAS BEEN ALLOWED TO COOL DOWN.
Carburetor adjustment (Fig. 17)
T
WARNING
○ The cutting attachment may be spinning during
carburetor adjustments.
○ Never start the engine without the complete
clutch cover and tube assembled! Otherwise
the clutch can come loose and cause personal
injuries.
In the carburetor, fuel is mixed with air. When the
engine is test run at the factory, the carburetor is
basically adjusted. A further adjustment may be
required, according to climate and altitude. The
carburetor has one adjustment possibility:
T = Idle speed adjustment screw.
Idle speed adjustment (T)
Check that the air fi lter is clean. When the idle
speed is correct, the cutting attachment will not
rotate. If adjustment is required, close (clockwise)
the T-screw, with the engine running, until the
cutting attachment starts to rotate. Open (counter-
clockwise) the screw until the cutting attachment
stops. You have reached the correct idle speed
when the engine runs smoothly in all positions well
below the rpm when the cutting attachment starts
to rotate.
If the cutting attachment still rotates after idle speed
adjustment, contact Tanaka dealer.
NOTE
Standard Idle rpm is 3000 min
Fig. 17
.
-1