PCM BO26-GSC-105-4X Mode D'emploi page 2

English
1. To fix the tool holder to the machine,
introduce the shank and then tighten
the 4 screws of fixations (Important,
watch that the screws have the
same strength of tightening).
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
BO26-GSC-105-4X
3. During the mounting or the dismounting
MARK : Never use the tool holder with
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 04.03.2019
of your tools, block the broach on flats
planned for that purpose, using an
adapted wrench.
4. The tool shank diameter should
never have a difference of more than
0.4 mm compared to the clamping
diameter of collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
empty positions. Use the supplied
protection plug.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
Document :
BO26-GSC-105-4x
Mode d'emploi
Page : 2 de 4
office@pcm.ch