Before Use; Before You Begin; Setting The Clock - Atag MC4111E Notice D'utilisation

3 Before use

3.1 Before you begin

• Open the door and remove the packaging material. Do not install the microwave
oven when it is damaged, but contact the manufacturer.
• Remove the protection foil from the outside of the microwave oven.
• Clean the inside of the oven and the accessories with a damp cloth. Do not use
abrasive cleaners or any strongly smelling detergents.
• Place the turntable in the middle of the microwave oven with the indentation for the
driving mechanism downwards.
• Connect the combi microwave oven to the mains supply.

3.2 Setting the clock

When the power is fi rst supplied to the microwave oven, you
must set the clock. In the display '00:00' will blink. The clock
will work as long as the microwave oven is connected to the
mains.
1. Turn the selection button to set the right time (between
00:00 and 23:59).
2. After you have set the right time, you will hear a beep and
the time stops blinking.
The clock has been set.
Notes
• If you want to change the time later on, you have to press and hold the clock button.
The actual time disappears and then the time will blink in the display. Turn the
selection button to set the new time. Press the clock button again to confi rm the
setting or wait for the time to stop blinking in the display.
• If you do not want to see the clock in the display, press the clock button briefl y. The
time disappears. Press the clock button again, and the clock appears in the display
again.
93