Cooper Lighting Solutions Corelite Continua SQ4 Instructions D'installation page 6

Installation Instructions - Continua SQ4 Suspended LED
7 End Caps
Secure endcaps to fixture using cast joiners. Close all
tabs once complete.
7 Sensor End Caps (if applicable)
Wave Washer
Place Wave Washer on
the neck of the sensor
body
6
Cooper Lighting Solutions
C
2X
Decorative Nut
Tighten Decorative nut
while holding the Sensor
body in place
Installation instructions
8
Sensor Side Mount (if applicable)
NOTE: Sensor connection
to supllied sensor wiring
should be made in the sensor
housing.
9 Fixture Maintenance and Cleaning
Always follow recommended cleaning and
handling procedures when cleaning the lens. It can
be permanently damaged if cleaned or handled
improperly.
Blowing off the Surface of the Lens
Dust and other loose contaminants should be blown
off before any other cleaning technique is employed.
Using compressed air over the entire lens is
recommended to prevent static buildup.
Additional Cleaning Methods
Fingerprints and large dust particles can be
removed by gently wiping the surface with a clean
microfiber cloth. If additional cleaning is required it
is recommended to use Clorox® wipes to remove
remaining contaminants by gently rubbing the
affected area and allowing to air dry.