Protecto SST-P 12/20 F30 Instructions De Montage page 59

ENGLISH
11.6.2.4. Troubleshooting
Fault
Device not working
Red lamp permanently ON
or blinking, function check
OK
Red lamp permanently ON,
function check not OK
11.6.2.5. Specifications
Model
Ventilation system
Ventilation housing material
Impeller material
Flow
Total pressure
Speed
Sound level* Lp2A
LEDs
Operating cycles
Signal output
Contact power
Power supply
Current consumption
Frequency
Motor protection
IP protection
Weight
* At a distance of 3 m in accordance with DIN 45635, with air connections on the suction and discharge
sides
Protectoplus Lager- und Umwelttechnik GmbH, Tel. +49 4331/4516-0, Fax +49 4331/4516-11
Cause
No power
Device defective
System resistance
too high
Ventilation system
sticks, control loop
defective
: SST-AL
: RCRv75/2m
: Acid and lye-resistant plastic
: Acid and lye-resistant plastic
: 50 to 200 m³/h
: 250 to 50 Pa
: 2400 to 2800 rpm
: 35 dB(A)
: ROT = Error, GREEN = Service
: Min. 1,000,000
: Potential-free via DIN bush
: Max. 230 V / 8 A
: 230 V +5/-10%
: Max. 0.45 A
: 50 Hz
: PTO 90°C
:
CE II _/3G c e IIB T4
: 8 kg
Internet: www.protecto.de, E-mail:
Remedy
Check the mains supply
Send in the device
Change the duct layout, reduce the air
velocity in the duct (by increasing the
cross-section)
Send in the device
Signal output assignment
Max. 230 V / 8 A
info@protecto.de
- 59 -