Before each fault clearance
switch off device
wait until the hoeing tools is stationary
pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Device doesn't start
The device operates with
interruptions
Unusual sounds
Unusual vibrations
Unsatisfactory result
20
Possible faults
Possible cause
No power
Extension cable defect
Main plug, motor or switch defect
Protective motor switch has tripped
Extension cable defect
Internal fault.
ON/OFF button defective.
Sets of tines are blocked
Loose screws, nuts or other fasteners
Lack of lubricant
Lubricant emerges
Sets of tines damaged or dull
Excessive working depth
Dull sets of tines
Insufficient working depth
Remedy
Check power supply, power socket and fuse
protection
Check extension cable, exchange defect cable
immediately
Have main plug, motor or switch checked by
an approved electrician or replaced by original
spare parts
1. Excessive working depth reduce the
working depth
2. Hoeing tools blocked remove the blockage
Allow the motor to cool down approx. 15
minutes before continuing to work
Check extension cable, exchange defect cable
immediately
Please contact the after sales service.
Please contact the after sales service.
Remove the blockage
Tighten all parts; contact customer service if
the noises continue to occur.
Refill lubricant.
Please contact the after sales service.
Please contact the after sales service.
Reduce the working depth.
Please contact the after sales service.
Increase the working depth.