Important Safety Instructions - Hayward SharkVAC XL Manuel Du Propriétaire

This robotic swimming pool cleaner has been manufactured with the highest degree of care and concern for
safety. We suggest the following safety precautions become part of your pool safety regulations:
1. ALWAYS PUT THE MACHINE INTO THE WATER BEFORE connecting it to the GFCI protected electrical
outlet.
2. IT IS IMPORTANT FOR SWIMMERS' SAFETY TO REMOVE THE UNIT IMMEDIATELY FOLLOWING USE. THIS
CAN ALSO IMPROVE THE OPERATING LIFE OF YOUR CLEANER.
3. BE CERTAIN THE machine IS ONLY PLUGGED into a grounded electrical outlet equipped with an
approved and properly operating ground fault circuit interrupter (GFCI).
4. DO NOT HANDLE MACHINE WHILE IT IS PLUGGED INTO THE ELECTRICAL OUTLET.
5. DO NOT USE AN EXTENSION CORD. THIS COULD CREATE A SAFETY HAZARD AND/OR DAMAGE YOUR
CLEANER.
6. ALWAYS STAY OUT OF THE POOL WHILE CLEANER IS IN OPERATION.
7. NEVER ALLOW PLUG TO ENTER THE POOL.
8. DO NOT OPERATE THE MACHINE OUT OF WATER. THIS WILL DAMAGE THE MOTOR SEAL AND VOID THE
WARRANTY.
9. DO NOT DRAG THE MACHINE OUT OF THE POOL AGAINST THE SIDE WALL. THIS COULD DAMAGE UNIT
AND/OR YOUR POOL WALL.
10. DO NOT BURY CORD. DO NOT OPERATE CLEANER WITH DAMAGED CORD. REPLACE DAMAGED
CORDS IMMEDIATELY.
WARNING - TO REDUCE THE RISK OF INJURY; DO NOT PERMIT CHILDREN TO USE THIS
PRODUCT UNLESS THEY ARE CLOSELY SUPERVISED AT ALL TIMES.
11. If the supply cord is damaged it must be replaced by the manufacturer, service agent, or
similarly qualified persons in order to avoid a hazard.
While the cleaner has been made to operate as safely as possible, we suggest you exercise
reasonable care in the handling of the vacuum and inspect the electrical cord frequently for damage
or wear, as with any other electrical appliance. After use, remove the unit and rinse with fresh
water and remove any twists that may be present in the cord.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
19