EN
ATTENTION: In case the safety cap (M) does not loosen, wait some minutes to allow the appliance to cool
down as there is still some steam under pressure. Press the steam push button (A) to exhaust the residual
steam in the boiler and proceed with cap removal again.
Emptying and cleaning the inside of the boiler tank
IMPORTANT: Clean the boiler tank at least once every month so as to remove any scale residues which
might affect the normal operation of the appliance.
IMPORTANT: Switch off the appliance, unplug it from the mains power and leave it to cool before cleaning
out the boiler tank, so as to avoid the risk of scalds.
•
Bleed out any pressure remaining in the boiler tank (L) using the steam button (A) on the gun (C), pointing the jet into
a suitable container.
•
Slowly unscrew the boiler tank filler cap (M) and remove it completely.
•
Slowly add tap water to the boiler tank (L) to prevent any spurts of steam; shake the appliance and turn it upside down
to empty it. Repeat the operation several times.
WARNING: Never add scale removers, vinegar or other perfumed substances to the tank, as these risk
damaging the appliance with immediate cancellation of the warranty.
PROBLEM
No steam comes out of the
nozzle
The nozzle is
dispensing little steam
CLEANING AND MAINTENANCE
TROUBLESHOOTING...
CHECK
Steam ready light (H)
off
Steam
ready light (H)
on
Steam
ready light (H)
on - Water in the boiler tank
(L)
Steam
ready light (H)
on
POSSIBLE CAUSES
Cold boiler tank
No water in the boiler
tank (L)
Malfunction
Cold boiler tank
- 18 -
POSSIBLE REMEDY
Wait for the steam ready
light to switch on (H)
Refill the tank, as descri-
bed in the paragraph
"INSTRUCTIONS FOR
USE"
Contact an ASSISTANCE
CENTRE
Wait for the boiler tank (L)
to heat up