Pioneer PDP-S23-LR Mode D'emploi page 6

English
• Organize cables together using the
speed clamps provided with the
plasma display.
Insert 1 into an appropriate hole on the rear of the unit, then
snap 2 into the back of 1 to fix the clamp.
1
Speed clamps are designed to be difficult to undo once in
place. Please attach carefully.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over time
and may be damaged when removed.
To attach the speed clamps to the main unit
Connect the speed clamps using the 1 hole marked with •
below, depending on the situation.
6
2
CABINET MAINTENANCE
÷ Use a polishing cloth or dry cloth to wipe off dust and
dirt.
÷ When the cabinet is very dirty, wipe with a soft cloth
moistened with water-diluted cleanser; then wipe again
with a dry cloth. Do not use furniture wax or cleaners.
They may damage the surface of the cabinet.
÷ Never use thinner, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will cor-
rode the surfaces.
÷ When a chemical cloth is used, read the cautions for the
chemical cloth carefully.
SPECIFICATIONS
Cabinet : Bass-reflex type
Used speakers (two-way system) :
Woofer (for low tones) ............................ Oval cone type
Tweeter (for high tones) ....................... 2 cm dome type
Nominal impedance ..................................................... 8 Ω
Frequency Range ..................................... 60 to 20,000 Hz
Sensitivity ................................ 82 dB/W (at 1 m distance)
Permissible input :
Max. input ............................................................... 13 W
Rated input .............................................................. 4 W
Crossover frequency ................................................ 2 kHz
External Dimensions
PDP-S25-LR (for 50 in. (127 cm))
........................................ 95 (W) x 737 (H) x 62 (D) mm
PDP-S26-LR (for 43 in. (110 cm))
........................................ 95 (W) x 652 (H) x 62 (D) mm
Weight
PDP-S25-LR (for 50 in. (127 cm)) .......................... 1.7 kg
PDP-S26-LR (for 43 in. (110 cm)) .......................... 1.6 kg
Accessory parts (for 2 speakers)
.............................................................. Speaker cable x 2
........................................................ Screw (M5 x 10) x 12
............................................... Bracket for flush mounting
................................................... Bracket for air mounting
................................................................ Padding strip x 2
................................................................................ Covers
................................................ Operating Instructions x 1
NOTE:
Specifications and design subject to possible modification
without notice, due to improvements.
Right (RIGHT) x 2
Left (LEFT) x 2
Right x 1
Left x 1
Upper x 2
Lower x 2
Published by Pioneer Corporation.
Copyright © 2004 Pioneer Corporation.
All rights reserved.