Globus MY STIM Manuel D'utilisation page 50

How top ut the program
You can put the program in Pause mode by pressing switch OK of Joypad. The intensity turns to
0. Start stimulation again by pressing OK.
The program continues where stimulation was shut off.
During the pause the lightening PAUSE description will appear.
How to stop the program
To stop the program hold down the bottom OK for 3 seconds.
How to display the remaining time of a program.
During the program, the remaining time of the ongoing phase is displayed. If you want to see
the remaining total time press switch TIME.
It will be displayed for two seconds and all the phase indicators are filled.
How to change the phase time.
To change the phase time, press switch Function fn; the time indicator of the phase in progress,
starts blinking; press switches Up and Down of Joypad to change it.
The new entered time will be automatically confirmed after two seconds of visualisation.
Jumping phase.
While stimulating, you have the option to jump to the next or previous sequence. Hold down the
push button right or left for 3 seconds.
Increasing and decreasing the intensity
To increase or decrease the intensity on each channel, press the corresponding switches Up or
down.
If you want to increase or decrease all the channels simultaneously., press switches
Up or Down of Joypad.
50
in pause.
Multi_Elite_Mystim_Rev. 09.14 data di emissione 29_09_14