Table des Matières
Publicité
1
2
3
6
English
Installation
Connect the valves to the spout tee using the cop-
per tubes and ⅜" compression fittings.
Install the mounting rings, friction washers, and
fiber washers on the valves.
Install the mounting nut and washer on the spout
tee.
If the mounting surface is thin, install the white
plastic spacer. Otherwise, it may be omitted.
Screw the mounting rings and nuts down as far as
they will go.
Push the spout tee and valves up through the
mounting surface as far as possible.
Install the sealing ring and spout adapter on the
spout tee.
The pin on the bottom of the spout
adapter must go through the hole
on the mounting surface.
Install the stop rings on the valves.
Install the escutcheon adapters on the valves.
The stop rings will stop the adapters at the correct
mounting height.
Publicité
Table des Matières
