Inspection On Delivery - SPIDO COMBO-CARTOUCHE Manuel Utilisateur

EN
• In the event of damage to the cable,
both cable and plug must only be
replaced by specialised personnel to
avoid damage.
• Turn off the power supply to the
device and allow it to cool before
cleaning, maintenance and storage.
• Protect the electrical components
against moisture. Never immerse
them in water or another liquid when
cleaning or during operation in order to
avoid any electric shock. Never put the
device under running water.
* Do not bury the electrical cables
* Never carry out maintenance on the
device when it is powered up.
Operating safety.
Filter systems cannot operate when
dry (without water)! The water
ensures cooling – the warranty covers
no replacement if it is operated when
dry!
• Never place the pump or filter in your
pool. Do not use the filter system when
the pool is in use.
• Install this product at a sufficient
distance from the pool to prevent
children from using it to gain access
to the pool. • Never immerse the filter
system, the power cable or plug in
water or any other liquid.
• NEVER carry out maintenance
or repair on this device when it is
powered up.
• RISK OF ENTRAPMENT
SUCTION WHICH CAN RESULT IN
SERIOUS INJURY OR DEATH.
2. INSPECTION
ON DELIVERY
This product may be damaged if the
packaging is opened with a knife or
other sharp objects without precaution.
Please open the packaging with great
care.
» Remove the product from the
packaging.
» Make sure that all the elements have
been provided and are complete.
» Check the product and components
for damage. Do not use a damaged
product. If necessary, contact the
service centre mentioned at the end of
this manual.
3. OPERATION
The filter balls in the filter tank ensure
efficient long-term filtration of dirt
particles and floating debris. Dirty
water is extracted from the pool via
the suction pipe, passes through the
filtration pump, and is then reinjected
from above into the filtration tank.
When the water passes through the
filtering balls in the filtration tank, dirt
particles are collected in the balls and
are thus removed from the pool. The
purified water then returns to the pool
via the return pipe.
4. POSITIONING
Determine the installation area so
as to leave a sufficient safety margin
from the wall of the pool. We also
BY recommend installing the filter system
on a flat base (washed concrete slabs,
etc.).
(Figure 1)