Select A Location - Orbit 57894 Manuel De L'utilisateur

1. Select a Location

When choosing a location for your timer, consider the
following:
• Choose location near a power source (if hard wiring) or
electrical outlet (applicable only to U .S . retail timers)
• Ensure operating temperatures are not below 32° or
above 158° Fahrenheit (below 0° Celsius or above 70°
Celsius)
• Place it away from direct sunlight if possible
• Ensure at least 9" of space to the left of the sprinkler
timer box for the door to swing open after installation
• Locate the timer where there is easy access to sprinkler
wire (from valves) . If mounted in an outdoor location,
shut the compartment door to keep the timer safe
from weather damage . To lock: insert the key and turn
clockwise to the locked position
Note: Sprinkler timers are weather-resistant to UL-50 and ETL
Listings, but should not be placed in areas where continuous
water could cause damage.
6
2. Mount the Timer
• Use the mounting template (included) to mark the
mounting screw location on the wall . See figure 1
• Install a No . 8 screw (included) into wall in the upper
template location . Leave the screw head protruding 1/8"
(3mm) from wall . Use expanding anchors (included) in
plaster or masonry, if necessary, for a secure hold
• Slip the timer over protruding screw (using keyhole slot
in back of timer) . See figure 2
• Drive a No . 8 screw through one of the two pre-formed
holes located in lower back cabinet . See figure 2
Figure 1: Use Mounting Template (included)
p 801 295 9820
f 801 951 5815
www.fl uid-studio.net
1065 South 500 West
Bountiful, Utah 84010
®
mounting holes
Figure 2: Hang timer on screw using keyhole
MOUNTING TEMPLATE
4.17"
GABARIT D`INSTALLATION
(106 mm)
GUIA DE COLGAR
3
dimensions:
proof no:
fl at: w: 9" h: 7"
date: 10.05.07
fi nished: w 9" d: 0" h 7"
des: SM spck: SM
colors
job no:
07WTM005259
crop color color
Registration non printing non printing
client: Orbit
PMS PMS
PMS
sku: 57880 K ???? ???? ????
upc: ? ????? ????? ?
additional instructions:
·
fi le name:
07WTM005259
·
57880-04 rA.indd
software: Illustrator CS2
Keyhole
1/8"
No. 8 Screw
Wall
Pre-formed
Printers are responsible for
meeting print production
requirements. Any changes
must be approved by the
client and Fluid Studio.
printed piece must meet
designated specifi cations
on this form.
© 2007 Fluid Studio. This
work is the property of Fluid
Studio, and cannot be used,
reproduced or distributed
in any way without their
express permission.