Sony SPP-A700 Mode D'emploi page 42

Troubleshooting (continued)
Symptom
You hear five short error beeps
and can't store the Phone
Directory.
Phone Directory dialing is
incorrect.
The handset doesn't ring when
calling from the base unit.
You can't hear anything from
the speaker.
No time stamp is heard.
You can't record the greeting
properly.
The phone does not record
messages
The phone doesn't accept your
security code.
You hear error beeps when you
enter your security code.
A long confirmation beep
doesn't sound when you enter
your security code.
EN
42
Additional Information
Remedy
• Make sure you follow the procedure in storing the
number correctly (page 16).
• Store a correct number (page16).
• Set the RING ON/OFF switch to ON.
• Use the SPEAKER VOLUME control on the base unit
to increase the speaker volume.
• Make sure the day and time are set (page 21).
• The day and time may have been cleared due to a
power interruption. Set them again (page 21).
• Keep your message between two seconds and four
minutes.
• Make sure you speak about 12 inches (30 cm) away
from the microphone when recording.
• Check the answering mode. The phone cannot record
messages in ANN ONLY mode.
• Make sure that the memory is not full. When the
remaining recording area is less than one minute, the
phone switches to ANN ONLY mode automatically.
• The phone doesn't record a message that is shorter
than two seconds.
• Even if the message is longer than four minutes, the
phone only records up to four minutes.
• Make sure you call from a touch-tone phone.
• Make sure you entered your security code within two
seconds after you've entered (#).
• Make sure the security code is correct.
• Enter your security code while the greeting is being
played back.
• Make sure you are calling from a touch-tone phone.