Introduction; Proper Use; Features And Equipment; Included Items - Parkside PDS 290 A1 Instructions D'utilisation Et Consignes De Sécurité

Introduction

Delta sander PDS 290 A1
Introduction
Q
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as described
and for the specified applications. If you pass the
product on to anyone else, please ensure that you
also pass on all the documentation with it.

Proper use

Q
This device – when combined with the appropriate
sandpaper – is suitable for dry-sanding wood, plastic,
metal, filler and painted surfaces. The device is par-
ticularly suitable for corners, profiles or difficult to
access places. Any other use or modification to the
device shall be considered as improper use and
could give rise to considerable dangers. We will
not accept liability for loss or damage arising from
improper use. Not suitable for commercial use.

Features and equipment

Q
ON / OFF switch
1
Oscillation speed setting wheel
2
Mains lead
3
Dust extraction spout
4
Ventilation openings
5
Backing plate (360° rotatable)
6
Adapter for external vacuum extraction
7
Reducer piece
8

Included items

Q
1 Delta sander PDS 290 A1
3 Sanding sheets
1 Adapter for external vacuum extraction
6 GB/IE
1 Reducer piece
1 Operating instructions

Technical information

Q
Nom. power input:
Rated voltage:
Nominal speed:
Nom. oscillation speed: n
Backing plate:
Protection class:
Noise and vibration data:
Measured values for noise are determined in accord-
ance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1.5 m / s
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions.
Regularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
290 W
230 V∼ 50 Hz
n 6000–11000 min
-1
0
12000–22000 min
0
360° rotatable
II /
78 dB(A)
89 dB(A)
3 dB
= 6.7 m / s
2
2
-1