Table des Matières
Publicité
3
2
4
1
5
8
English
Installation
Cut the plaster shield so that it extends ¹⁄₁₆" - ⅛" from
the finished wall surface.
1
1
4 mm
Remove the flush insert screw using a 5 mm Allen
wrench .
Remove the flush insert and seals.
2
5 mm
Insert the function block.
Tighten the function block screws.
4 mm
Close the stops using a 4 mm Allen
wrench.
Seal the wall around the plaster
shield with waterproof sealant .
Failure to seal the wall can lead to
possible water damage.
Publicité
Table des Matières
