Control Panel Display Codes; Programming Instructions - Tennant 3610 Manuel Utilisateur

CONTROL PANEL DISPLAY CODES:

Safety code
C22
C14
FS0
SP1
Yellow led lit
Red led flashes
P1.X
P2.X
SF.X
X = A VALUE FROM "0" TO "5"

PROGRAMMING INSTRUCTIONS:

The program allows you to adjust the brush pressure and the frequency of the automatic filter shaker.
1. Turn on the machine.
2. Hold down the hourglass button located to the right of the display for about 5 seconds until a P1.X is displayed. X=
0 to 5
3. P1 is the brush pressure setting for sweeping mode 1. You can change the value of X from 0 to 5 using the fan
button to increase and the filter shaker button to decrease. The higher the value the more brush pressure. Factory
setting is 2.
4. Push the hourglass button once. The display will show a P2.X. This is the setting for sweeping mode 2. To change,
use the same procedure used in step 3. Factory setting is 4.
5. Push the hourglass button once. The display will show a SF.X. X = the frequency in minutes the automatic filter
shaker will operate. To change, use the fan button to increase and the filter shaker button to decrease. Factory
setting is 3.
6. To return to operational mode, hold the hour glass button down for about 5 seconds until the battery voltage is
displayed.
Brush Pressure Mode Buttons
Cause
Short circuit brush protection:
stops all functions
Dissipater at high
temperature. Activates if
temperature is over 194° F
Worn brushes
Brush motor restricted
Battery in reserve
Battery discharged
Sweeping mode 1 button
programming activated
Sweeping mode 2 button
programming activated
Filter shaker program
setting activated
Reset by turning OFF the
machine and starting again
The machine resets when
temperature lowers under 176° F
Replace brush
Inspect brush for obstruction.
Restart machine to reset
Machine continues to work.
Only a warning that the battery
is near discharge
Machine stops all functions
Turn off machine and charge
the battery
See programming
See programming
See programming
Hourglass Button
Fan Button
Filter Shaker Button
8
Actions to take