Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – WP Wall Pack LED
INSTALLATION
Tools required:
Phillips head screwdriver, 1/4" Drill Bit.
1.
Open the fixture by loosening the two Phillips head
screws on the side opposite the hinges: Disconnect
the male and female connectors. (Figure 1) Remove the
glass door assembly, and gently set it aside.
2.
The back plate has a cast-in drill pattern template to
match standard recessed junction boxes (B), surface
mount holes (A), or 1/2" NPT tapped hole for surface
conduit (C): Prepare the back plate for mounting by
drilling or knocking out the appropriate holes. (Figure 2)
3.
Line up the back plate in the desired location and
mount securely (hardware not supplied).
N
otee:
Mounting height to be a minimum of 6 feet.
A - Optional surface mounting location
B - Optional junction box mounting location
C - 1/2" NPT tapped holes
4.
If using electrical conduit, remove the screw cap from
the desired conduit hole and replace with conduit,
sealing the conduit hole afterwards. Route the branch
circuit wires inside the fixture. If using a junction box,
bring the branch circuit wires through the rear hole into
the fixture.
5.
Splice the branch circuit power leads to the fixture
power leads, black to black (hot), white to white
(neutral), and green to green (ground).
6.
Replace the lens assembly using the provided Phillips
head screws.
IMPORTANT
To weatherproof your outdoor installation, use silicone
sealant for all holes in the fixture housing (mounting,
conduit, plugs, photocontrols, etc.) and all edges between
the fixture housing and the mounting surface. If you
remove one of the conduits plugs and use an alternate
conduit location, add thread sealing tape to plug to ensure
watertight seal.
2
COOPER LIGHTING SOLUTIONS
IB514036EN
Installation instructions
Glass Door
Assembly
Male
Connector
Figure 1.
C
C
A
Figure 2.
Back Plate
Female
Connector
C
A
C
B
C
A
B
C
Publicité
