Unpacking/Delivery - Nilfisk SR 1000S B Instructions D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

USER MANUAL

–

Do not wash the machine with direct or pressurised

water jets, or with corrosive substances. Do not use

compressed air to clean this type of machine.

–

Do not use the machine in particularly dusty areas.

–

While using this machine, take care not to cause

damage to other people, and children especially.

–

The storage temperature must be between 0°C and

+40°C.

–

The machine operating temperature must be between

0°C and +40°C.

–

The humidity must be between 30% and 95%.

–

Always protect the machine against the sun, rain and

bad weather, both under operation and inactivity

condition.

–

Do not use the machine as a means of transport.

–

Do not allow the brooms to operate while the machine is

stationary to avoid damaging the floor.

–

In case of fire, possibly use a powder fire extinguisher,

not a water one.

–

Do not bump into shelves or scaffoldings, especially

where there is a risk of falling objects.

–

Adjust the operation speed to suit the floor conditions.

–

Avoid stopping the machine movement by turning the

ignition switch to "0", and avoid pressing the emergency

push-button, before the machine has stopped by

releasing the accelerator pedal or by pressing the brake

pedal.

–

Do not tamper with the machine safety guards and follow

the ordinary maintenance instructions scrupulously.

–

Do not remove or modify the plates affixed to the

machine.

–

In case of machine malfunctions, ensure that these are

not due to lack of maintenance. Otherwise, request

assistance from the authorised personnel or from an

authorised Service Center.

–

In case of part replacement, order ORIGINAL spare

parts from an authorised Dealer or Retailer.

–

To ensure the proper and safe operation of the machine,

have the scheduled maintenance, detailed in the

relevant chapter of this Manual, performed by the

authorised personnel or an authorised Service Center.

–

The machine must be disposed of properly, because of

the presence of toxic-harmful materials (batteries, oils,

etc.), which are subject to standards that require

disposal in special centres (see the Scrapping chapter).

–

If the machine is used according to the instructions, the

vibrations do not cause dangerous situations. The

machine vibration level is less than 2.5 m/s

(98/37/EEG-EN-1033/1995-EN 1032).

–

When lead (WET) batteries are installed, do not tilt the

machine for more than 30° from the horizontal plane to

prevent the highly corrosive acid from leaking out of the

batteries. When the machine is to be tilted to perform

maintenance procedures, remove the batteries.