Programming The Run Times; Deleting The Run Times - Becker Centronic MemoControl MC441-II Notice De Montage Et D'utilisation

Programming the run times

1. If necessary, run the roller shutter or blind to the opposite limit position.
2. Wait for the time you wish the automatic drive command to be executed.
3. At the desired time, press and hold the relevant direction button until the
drive briefly stops after approx. 6 seconds and then continues to the limit
position.
4. Release the direction button.
The receiver has saved the current time for this direction of travel. Proceed in
exactly the same way with the other direction of movement.
In the slide switch position " ", no automatic drive commands will be ex-
ecuted. The saved run times are retained.

Deleting the run times

When deleting, both run times are always deleted.
To delete the UP and DOWN run time, press the STOP button for 10 seconds.
Acknowledgement is given by a "click click" from the drive, or by a "shift" of
the shading solution.
The run times are now deleted.
Channel
The channel of a transmitter can be programmed into one or more receivers.
One receiver is operated through an individual command, several receivers
through a group command.
Channel indicator lamp
A radio signal is indicated by the channel indicator lamp lighting up. When the
battery starts to lose power, the channel indicator lamp flashes when transmit-
ting. The transmission strength and the radio range decrease as battery power
declines. If the channel indicator lamp no longer lights up when a button is
pressed, the battery must be replaced.
17 - en