Amplicomms BTH 1410-NL Mode D'emploi page 24

O
PERATION
Operation
Hearing damage due to high volumes!
Do not continuously expose yourself to high volumes.
1 Switch the ON/OFF switch on the receiver to ON position.
2 Make sure the Bluetooth connection is established (indicator LED lights
blue)
3 The neck-loop induction cable can transmit the audio signal to the hearing
aid device for listening.
4 Adjust the desired volume.
5 Adjust the tone clarity setting if necessary.
To set the tone clarity briefly press the TONE button repeatedly.
- 1 short beep: Treble boost
- 2 short beeps: Bass boost and treble boost
- 3 short beeps: Bass boost
- 1 long beep: Flat
6 Adjust the balance (left/right) if neccessary.
Note: When the battery level is low, the indicator LED sparkles in blue
(Bluetooth mode) or in green (MIC mode). You will hear 3 beeps every
minute and 1 double-beep in the forth minute. The receiver will switch
off automatically in the fifth minute.
20
Helpline UK 0844 800 6503
(See page 25 for costs and hours of operation)