Example Of Use - Facom DX.CONECT Notice Originale

EN
• Never use any components of the DX.CONECT with voltage more than 49V AC or DC.
• Always respect all the car manufacturers procedure.
• Take care of regulation regarding personal protection equipments.
IMPORTANT : All theses products must be only used on non dangerous voltage and under 49V AC or DC.
Never used it on 110V or 220V networks.
WHY USING DX.CONECT ?
All these accessories can be used with electric tester or diagnostic equipment.
For : Automotive, motor bike, bike, marine...

EXAMPLE OF USE

Example of use : Test of the airbag circuit
Example of use : Test of MAP, temperature sensor, throttle circuit
WARNING
• Because probe designed for high voltage is not adapted to
automotive diagnostic.
• Automotive diagnostic required measure across small
connectors without damage it.
• Access is key for diagnostic measures.
The dummy airbag replace an airbag actuator. It's useful to test
an airbag circuit with a diagnostic equipment to validated if the
actuator is really wrong before replace it.
Replace an sensor based on variable resistance like pressure
sensor, throttle position sensor, temperature sensor.... by test
potentiometer and check the line and the ECU with diagnostic
equipment using live components value.