Triton TSPS 370 Instructions D'utilisation Et Consignes De Sécurité page 10

Troubleshooting
Problem
No function when ON Button (5) is operated
Sanding Sleeve slips on drum
Large amounts of wood dust and chippings are on the
table surface
Sanding drum not operating at full speed or motor sounds
different to normal
EN
10
Possible cause
No power
Defective ON Button
Spindle Lock Nut (2) not tight enough
Dust Port (21) passage is blocked
Incorrect Table Insert used
Motor over-heating
Motor faulty
Solution
Check power supply
Have the switch assembly replaced at an authorised Triton
service centre
Tighten Spindle Lock Nut in small increments until the drum
secures the Sanding Sleeve
Turn OFF the machine at the mains. Remove the Sanding
Drum (25), Table Insert (26) and the spindle washer. Remove
the blockage from the dust extractor passage
Change to the correct-sized Table Insert
Switch OFF and allow to cool for a 1/2hr and check the
Motor Vents (17 & 22) are not blocked
Contact an authorised Triton service centre