Applications; Before Use - Metabo HPT ET 36A Instructions De Sécurité Et Mode D'emploi

English

APPLICATIONS

Power source for 36V products compatible with multi volt battery

BEFORE USE

1. Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation are adequate.
2. To prevent electric shock, connect to a power source equipped with a ground fault circuit
breaker.
3. Prior to use, make sure that the DC cord insulation is not torn or that the case is not cracked.
Do not use the product if there is a break in the DC cord, the insulation is torn, or the case
is damaged.
4. Before starting operation, make sure that the vicinity of the box's vent is free from any
wood shavings or iron powder.
Also, do not use in locations where iron powder is abundant, or in areas where there is rain,
snow or other water sources that could wet the product.
5. Make sure there are no solid metal material or liquid in the adapter box. Failure to do so
may result in damage.
6. Be careful not to step on the box. Also, make sure the box is placed in a location where it
won't be stepped on. Do not place in a location where the box could be immersed in water
when it rains.
REMOVAL AND INSTALLATION METHOD OF ADAPTER
NOTE: Before plugging into the receptacle, make sure the following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
: Do not use at voltage higher than indicated on the nameplate.
1. Connect the AC/DC adapter's power cord to the receptacle.
When connecting the plug of the adapter to a receptacle, the power lamp will lights in
green.
CAUTION: Never short-circuit the battery.
8
If charged at voltage higher than indicated on the nameplate, the
AC/DC adapter will burn up.
WARNING
: Do not use the electrical cord if damaged. Have
it repaired immediately.