Start-Up And Use - SCHOLTES SCHO 103E P Mode D'emploi

Start-up and use

! The first time you use your appliance, heat the empty oven with its door closed
at its maximum temperature for at least half an hour. Make sure that the room
is well ventilated before switching the oven off and opening the oven door. The
appliance may emit a slightly unpleasant odour caused by protective substances
used during the manufacturing process burning away.
! To make the setting process easier, press and hold the " " and " " buttons
to scroll through the numbers on the display rapidly.
! Each setting will automatically be stored in the appliance memory after 10
seconds.
! The touch controls cannot be activated if the user is wearing gloves.
! In order to optimise the cooking performance, when starting the selected
function, product settings will be applied that could cause a delayed start of
the fan and heating elements
Some models are equipped with a system of hinges which allows the door to
close slowly, without the user having to follow the movement through with his/
her hand. To use the system correctly, before closing the door:
• Open the door fully.
• Do not force the closing movement manually.
Control panel lock
! The control panel can be locked while the oven is off, once cooking has
started or finished and during programming.
To lock the oven controls, press and hold the
seconds. A buzzer will sound and the TEMPERATURE display shows the
key symbol "O—n". The icon will light up to indicate lock activation.
To deactivate the lock, press and hold the
seconds.
! When cleaning the appliance, the door lock may be closed accidentally
(there is an exposed spring). If this happens, reopen it by turning the door
lock upwards (see figure).
KO OK
WARNING! The oven is provided
with a stop system to extract the
racks and prevent them from
coming out of the oven (1).
As shown in the drawing, to extract
them completely, simply lift the
racks, holding them on the front
part, and pull (2).
button for at least 2
button again for at least 2
Setting the clock
! The clock can only be set when the oven is switched off. If the oven is in
standby mode, pressing the button once will display the current time
setting. Press it again to set the time.
After connection to the power supply network or after a blackout, the
button and the digits on the TIME display will flash for 10 seconds.
To set the clock:
1. Press the button.
2. Adjust the hour figure using the " " and " " buttons.
3. Once you have reached the correct hour value, press the
4. Repeat the above process to set the minutes.
If a blackout occurs, it will be necessary to reset the clock. If the
flashes on the display, this indicates that the clock has not been set correctly.
Setting the minute minder
! The minute minder may be set regardless of whether the oven is switched
on or off. It does not switch the oven on or off.
When the set time has elapsed, the timer emits a buzzer that will automatically
stop after 30 seconds or when any active button on the control panel is
pressed.
To adjust the timer proceed as follows:
1. Press button .
2. Set the desired time using buttons " " and " ".
3. Once you have reached the desired value, press the
The lit symbol will remind you that the minute minder is on.
To cancel the minute minder, press the
" buttons to set the time to 00:00. Press button
The icon will switch off to indicate that the minute minder has been
disabled.
Starting the oven
1. Switch the control panel on by pressing the
buzzer sounds three times (ascending) and all buttons light up in sequence.
2. Press the button corresponding to the desired cooking mode. The
TEMPERATURE display shows:
- the temperature associated with the mode, if programming manually;
- "Auto", if programming is automatic.
The TIME display shows:
- the current time, if programming manually;
- the duration, if programming is automatic.
3. Press the button to begin cooking.
4. The oven will begin its preheating phase, the preheating indicators will light
up as the temperature rises.
5. When the preheating process has finished, a buzzer sounds and all the
preheating indicator lights show that this stage has been completed: the food
can then be placed in the oven.
6. During cooking it is always possible to:
- change the temperature by pressing the
and " " buttons (manual modes only);
- set the duration of a cooking mode (see Cooking Modes);
- press the button to stop cooking. In this case the appliance stores the
temperature modified previously in its memory (manual modes only);
GB
button.
icon
button again.
button and use the " " and "
again.
button. The appliance
button, followed by the " "
23