Positioning The Unit; Before Using For The First Time - SEVERIN MW 7802 Mode D'emploi

●
Always place the microwave oven on a stable, level and heat-resistant surface, ensuring
that it is protected from any heat source or excessive humidity.
●
Do not operate the appliance outdoors.
●
Sufficient ventilation must be ensured at all
times. Do not place any objects on the unit,
and make sure that the following minimum
distances from any wall or other object are
maintained:
One side: 7.5 cm; other side unobstructed
Rear: 7.5 cm
Top: 30.0 cm
The feet on the base of the unit must not be
removed.
The unit must not be installed inside a cupboard; when positioning the unit, also ensure
that it is not placed directly underneath a cupboard or any other similar object.
Connection to the mains supply
The appliance should only be connected to an earthed socket installed in accordance with
the regulations. Make sure that the supply voltage corresponds with the voltage marked on
the rating label. This product complies with all binding CE labelling directives.
●
Remove any exterior and interior packaging materials. All these materials are suitable
for recycling.
●
Caution: Keep any packaging materials well away from children, as they are a potential
source of danger e.g. from suffocation.
●
After unpacking, and every time before connecting the unit to the power supply, check
the unit and its power cord carefully for any signs of damage. Also ensure that the door,
including the inspection window, door seals and locks, are not damaged or bent and that
it closes firmly against the support. This is important to ensure that no microwave energy
is allowed to escape during operation. For the same reason, the entire casing as well as
the inside of the oven must be carefully checked.
Should the unit show any signs of damage, it must not be used under any circumstances
until it has been repaired by a qualified technician.
●
Do not remove the protective film covering the inside of the door, nor the turntable
drive unit or the grey-brown protective cover (4) next to the light on the right of the
interior.
●
Insert the roller ring and the glass turntable into the unit.
●
Before the microwave appliance is used for the first time, let it heat up on the grill setting
(without the microwave function activated) for approximately 10 minutes. This will
remove the smell typically encountered when first switching on a grill. A little smoke
may be emitted; this is quite normal, but ensure there is sufficient ventilation.
Note: Do not switch the unit on in the microwave function unless the food to be heated or

Positioning the unit

Before using for the first time

16