Fastening And Connecting The Inverter - Dometic PERFECTPOWER PP 1002 Instructions De Montage Et De Service

Fastening and connecting the inverter

Rear view (fig. 2, page 3)
No. Description
1 Main switch
2 Connection for MCR9 remote control
3 Connection for an external switch contact
4 Earth connection
5 Fan
6 Negative terminal
7 Positive terminal
8 Fastening and connecting the inverter
8.1 Fastening the inverter
!
WARNING!
• Ensure the device is standing firmly.
Set up the device securely and fasten it in such a way that
– it cannot tip over or fall down
– it cannot move while the vehicle is in motion
• Take precautions necessary to ensure that it is out of reach of
children. Dangerous situations may occur which cannot be
recognised by children!
You can fasten the inverter using the holders supplied.
When selecting the installation location, observe the following instructions:
• Do not operate the device
– in wet or damp environments
– in dusty environments
– in the vicinity of flammable materials
– in spaces where there is a danger of explosion
• Do not expose the device to a heat source (such as direct sunlight or heating).
Avoid additional heating of the device in this way.
• Make sure the cables are the correct length and choose the installation location
near the battery supply.
12
PerfectPower
EN