Cleaning And Maintenance - Clatronic DR 2811 Mode D'emploi & Garantie

5....-05-DR 2811 NEW
Filling up the Water Boiler when using the Device
GB
If there is no more water in the vessel no steam is emitted when the steam
switch (4) is pressed. The water has to be filled up as follows:
1. Pull the power plug out of the socket!
2. Wait for approximately 5 minutes and release the residual pres-
sure with the steam switch!
3. Unscrew the safety lock (3) slowly and wait for a few seconds
before opening it completely until the excess pressure has
escaped.
4. Fill fresh water from the measuring beaker (8) by means of the fun-
nel into the boiler. Do not overfill! Do not exceed the amount of
water indicated on the measuring beaker! Take care of water splas-
hes that might come out of the boiler. In order to prevent the water
from splashing it should be filled into the funnel slowly after the
safety lock has been opened.
5. Fasten the safety lock again.
6. Insert the power plug back into the socket.
• Cleaning and maintenance must only be carried out when the power plug is
removed from the socket.
• Before putting the device away or cleaning it, it has to be allowed to cool down
completely.
• Please clean the device and the accessories only with a slightly moist cloth.
• Do not use strong cleaning agents of solvents for cleaning.
• In order to guarantee a long and trouble-free working life, lime residues have to
be rinsed out of the boiler once a month. Please do not use vinegar or other
anti-liming agents.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
42
16.09.2003 8:41 Uhr

Cleaning and Maintenance

Seite 42