Overview Of The Controls; Initial Operation - Clatronic DR 2811 Mode D'emploi & Garantie

5....-05-DR 2811 NEW
GB
• The device is equipped with a thermostat for temperature restriction, a safety
fuse and a safety lock.
• The device must not be opened during use.
• During use the device must not be tilted by more than 45° as boiling water
could be spilled together with the steam.
• Never direct the steam jet towards people, animals or electric devices (e.g. into
the oven).
• Please do not immerse the device in water or other liquids.
• When refilling, always pull the power plug from the socket.
• Do not overfill! Please do not exceed the amount of water indicated on the mea-
suring beaker.
• Store the device out of the reach of children.
• Please do not add anti-liming agents, solvents, alcohol or cleaning agents as
these may damage the device or have a dangerous effect.
1 Kettle/water tank
2 Connection nozzle
3 Safety lock
4 Steam switch
5 Handle
6 Connection cable
7 Hose
Filling up the Heating Boiler before Use!
Before the tank lock is opened the power plug must be removed
from the socket. Please make sure the device is depressurized by
pressing the steam switch.
Caution! Before unscrewing the lock (3) proceed as follows:
• Remove the power plug from the socket.
• Release the pressure by using the steam switch (4).
• If the device is still warm, please wait 5 minutes before removing the
seal completely. Press the seal downwards and turn.
Caution! Danger of Injury!
Please open the safety lock (3) only when no more steam comes
out of the nozzle. Shake any residual water out of the kettle (1). Then
fill the measuring beaker (8) and pour the water into the kettle. Use a
funnel if necessary. Re-fasten the safety lock (3).
40
16.09.2003 8:41 Uhr
Special Safety Advice

Overview of the Controls

Initial Operation

Seite 40
8 Measuring beaker
9 Non-woven fabric attachment
10 Brush attachment
11 Angle attachment
12 Nozzle attachment
13 Universal cleaning attachment
14 Window cleaning attachment