Waeco PerfectView MC402 Guide De Démarrage Rapide page 21

MC402
3 Operating the moniceiver
I
NOTE
 The moniceiver can be operated using the buttons on the de-
vice display or using the remote control.
 An acoustic signal acknowledges the function that is selected.
The acoustic signal can be deactivated using the SETTINGS
menu. You can find additional information on the settings for
this device in the installation and operating manual.
Switching the device on and off
➤ Press the ON/OFF/VOLUME knob or the POWER button on the remote
control to switch on the device.
✓ The device switches on with the settings which were activated the last
time it was used.
➤ Press and hold down the ON/OFF/VOLUME knob for two seconds or
press the POWER button on the remote control to switch off the device.
Selecting the audio/video source
➤ Press the MENU button on the device.
✓ The menu for the required source appears on the display.
You can also select the audio/video source via the remote control. To do this,
press the SRC button on the remote control until you have selected the re-
quired source.
You can also select the audio/video source via the display. To do this, touch
the required source on the display.
I
NOTE
A source cannot be selected if it is not ready to play. After insert-
ing the storage medium, wait a few seconds until the device has
read the available files automatically and shows it on the display.
EN
Operating the moniceiver
21