Switching Off; Maintenance / Care - Futech MULTI SQUARE 5 Mode D'emploi

SWITCHING ON (FIG. I)
∙ Position the tool and level using the levelling feet [4].
∙ Switch on using the control button [1]. The laser lines at a 90° angle
in the forward direction are activated.
Important
The projection accuracy of the 45° and 90° angles is dependent on
the exact alignment of the device relative to the projection plane!
OPERATION (FIG. II)
∙ Press the control button once. Forward directed 90° lines are ac-
tivated.
∙ Press the control button twice. Forward directed 45° and 90° lines
are activated.
∙ Press the control button three times. Forward and backward direc-
ted 45° and 90° lines are activated.
∙ Press the control button for longer than four seconds. The currently
visible lines are switched to pulsing mode for handheld receiver
operation.

SWITCHING OFF

∙ Press the control button four times. The tool switches off.
BATTERY ALMOST DISCHARGED
∙ Laser lines flash.

MAINTENANCE / CARE

Do not use aggressive cleaning agents or solvents. Clean the laser
windows with a soft cloth. In the unlikely event of a failure or defect,
have the appliance examined and repaired by an authorised custom-
er service point.
www.laseto.be www.laseto.be
GB
19