Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All operating elements and connections described
can be found on the fold-out page 3.
1 Operating Elements and Connections
1 Transmitting antenna
2 Power switch
3 LC display; indicates the transmitting frequency
and the charging status of the batteries during op -
eration
4 Microphone connection (4-pole mini XLR jack)
5 Key
for increasing the frequency (in the fre-
quency adjusting mode) and for activating the lock
function (in the lock mode)
6 Key
for reducing the frequency (in the frequency
adjusting mode) and for deactivating the lock func-
tion (in the lock mode)
7 Key SET
with the unit not locked:
to recall and to exit the adjusting modes for fre-
quency and lock function → chapters 5.1 and
5.2.1
with the unit locked:
to recall and to exit the adjusting mode for the
lock function → chapter 5.2.2
8 Locking for the control part;
to unlock the control part, press down the two
latch ing buttons so that it unlocks and can be dis-
placed upwards (figs. 1, 2) or downwards (fig. 3)
9 Belt clip (can also be mounted if it is turned by 90°
or 180°)
10 Gain control; for matching the input sensitivity turn
the control with the supplied adjusting key
11 Battery compartment for two 1.5 V batteries of size
AA (R6)
2 Important Notes
The unit corresponds to all relevant directives of the
EU and is therefore marked with
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not correctly operated
or not repaired in an expert way.
If the unit is to be put out of operation defini -
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.
Do not put exhausted batteries/defective rechargea-
ble batteries into the household rubbish but take
them to a special waste disposal (e. g. collective con-
tainer at your retailer).
3 Applications
This multifrequency pocket transmitter is provided for
connection of a Lavalier microphone, headband micro-
phone, or instrument microphone and makes up a
wireless audio transmission system together with the
multifrequency receiver US-9001D / 5 from JTS. Within
the UHF frequency range of 518 – 542 MHz the trans-
mitting frequency can be selected as desired (fre-
quency spacing 125 kHz).
The pocket transmitter is supplied with a stable
transport box and the Lavalier microphone CM-501.
3.1 Conformity and Approval of the transmitter
Herewith, MONACOR INTERNATIONAL declare that
the unit PT-950B / 5 is in accordance with the basic
requirements and the other relevant regulations of the
directive 1999 / 5 / EC. The declaration of conformity
can be found in the Internet via the JTS home page
(www.jts-germany.de).
This unit may be operated in the following countries:
DE
In the Federal Republic of Germany, the pocket trans-
mitter requires a frequency assignment (for which a
fee is charged).
In other countries, it is necessary to apply for a cor -
responding approval. Prior to operating the pocket
transmitter outside Germany, please contact the
®
.
7
Publicité
Table des Matières
