Technical Specifications; Symbols - Stiga C 1.8 Manuel D'utilisation

IDENTIFICATION OF MAIN COMPONENTS / SYMBOLS
Maximum noise and vibration levels [1]
Operator ear noise pressure level
– Measurement uncertainty
Measured acoustic output level
– Measurement uncertainty
Sound power level guaranteed
Vibration level
– Measurement uncertainty

TECHNICAL SPECIFICATIONS

Voltage
Power frequency
Overload protection
Motor power
Bar length
Cutting length
Chain speed
Weight
Oil
[1]
Notice:
The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric equipment
as well as temporary estimates of the load through the vibrations.
WARNING!
The vibration value may vary according to the usage of the machine and its fitted equipment, and be higher than the one indicated. Safety
measures must be established to protect the user and must be based on the load estimate generated by the vibrations in real usage conditions.
In this regard, all the operational cycle phases must be taken into consideration, such as switching off or idle running.

2. SYMBOLS

1
1) If you are using the machine every day in nor-
mal conditions, you can be exposed to a noise
level of 85 dB (A) or higher. Wear safety glasses
and hearing protection.
2) Warning!
3) Read the instruction manual before using the
machine.
4) Do not leave the machine in the rain (or in
damp con ditions).
EXPLANATORY SYMBOLS
ON THE MACHINE
(if present)
11) Direction in which the chain is mounted
12) Chain brake
13) Direction in which the chain runs
2 3
11
A 180 E
C 1.8 E • C 1.8
Model
ET SE 1814
SE 1814 Q
dB(A) 94.3
dB(A) 3
dB(A) 104,6
dB(A) 2,4
dB(A) 107
m/sec 4.686
2
m/sec 1.5
2
V~ 230 - 240
Hz 50
A 16
W 1800
cm 35
cm 33.5
m/sec 14
kg 5.00
ml 130
4 5
5) Wear strong working gloves.
6) Unplug the chain-saw immediately if the ca ble
(or extension lead) is cut or damaged.
7) Beware of kickback! Kickback is the rapid and
uncontrollable backward motion of the machine in
the direction of the operator.
8) Hold the machine fast with both hands to con-
trol the machine and reduce the risk of kickback.
12 13
14) Chain oil tank
15) Chain tension
A 200 E • XC 120 Q
CP 2.0 Q
SE 2014
C 2.0 E • C 2.0 ET
SE 2014 Q
SE 2016
SE 2016 Q
95.1 95.1
3 3
104,5 104,5
2,4 2,4
107 107
4.916 4.916
1.5 1.5
230 - 240 230 - 240
50 50
16 16
2000 2000
35 40
33.5 38.5
14 14
5.05 5.30
130 130
6 7
14
3
EN
A 220 EQ
C 2.2 E • C 2.2 ET
SE 2216
SE 2216 Q
96.1
3
104,8
2,4
107
5.285
1.5
230 - 240
50
16
2200
40
38.5
14
5.42
130
8
15