Table Des Matières; Controls And Displays; Explanation Of Warning Symbols And Notes; Package Contents - Hama Wireless Remote Release DCCS System Base Mode D'emploi

G Operating instruction
Content
Controls and Displays ............................................2
Explanation of Warning Symbols and Notes ...........2
Package Contents..................................................2
Safety Notes..........................................................2
Getting Started......................................................2
Operation..............................................................4
Care and Maintenance ..........................................4
Warranty Disclaimer ..............................................4
Service and Support ..............................................4
Technical Data.......................................................4
Recycling Information............................................4
Declaration of Conformity......................................4

Controls and Displays

A Wireless transmitter
1. Wireless transmitter shutter release
2. Wireless transmitter status LED
3. Slide control
4. Single-frame shooting
5. Continuous mode
6. BULB function
7. Time-delayed shutter release function
B Wireless receiver
8. Power
9. Wireless receiver shutter release
10. Wireless receiver status LED
11. Standard flash shoe connector / ¼" thread
C Channel selection
12. DIP switch
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference.

1. Explanation of Warning Symbols and Notes

Warning
This symbol is used to indicate safety instructions
or to draw your attention to specific hazards
and risks.
2
Note
This symbol is used to indicate additional
information or important notes.

2. Package Contents

• Wireless transmitter
• Wireless receiver
• These operating instructions

3. Safety Notes

• Do not use the product in moist environments
and avoid splashes.
• Do not use the product in the immediate vicinity
of heaters or other heat sources or in direct
sunlight.
• Do not bend or crush the cable.
• Do not drop the product and do not expose it to
any major shocks.
• Do not open the device or continue to operate it
if it becomes damaged.
• Do not use the product in areas where the use of
electronic devices is not permitted.
• Do not modify the product in any way. Doing so
voids the warranty.
• Dispose of packaging material immediately
according to locally applicable regulations.

4. Getting Started

4.1 Setting the DIP switch:
• Set one of the four channels on the wireless
transmitter (A) by moving the appropriate slider
of the DIP switch (12) in the ON direction (C).
• Also make this setting on the wireless receiver (B).