Assembly And Adjustments; Applications - Facom E.2015 Notice Originale

DESCRIPTION (FIG. 1)
a. On/off switch
b. Air vents
c. Kick-off stand
d. LCD air temperature indicator and adjuster
e. Nozzle
f. Tool hanging ring
g. Heat barrel cover

ASSEMBLY AND ADJUSTMENTS

. Air Temperature (fig. 1)
• Press and release the LCD air temperature indicator and adjuster (d) to set the desired temperature in 10˚ C
increments.
• To continously increase or decrease the temperature press and hold the LCD air temperature indicator and
adjuster (d).
• Release the indicator when desired temperature or minimum/maximum temperature is reached.
• The display shows the actual rising/falling temperature until the desired temperature is reached.
The desired temperature is stored in the memory of the tool. Each time the heat gun is turned on, the heat gun
heats to the last temperature setting, with respect to air flow. If unsure about the setting, always start with a low
temperature setting and gradually increase the temperature until the desired setting is reached.

. Applications

Setting Applications
Low • Drying paint and varnish
• Removing stickers
• Waxing and dewaxing
• Drying wet timber prior to filling
• Shrinking PVC wrapping and insulation tubes
• Thawing frozen pipes
Medium • Welding plastics
• Bending plastic pipes and sheets
• Loosening rusted or tightly fastened nuts and bolts
High • Removing paint and lacquer
• Soldering plumbing joints (with tin)
• Removing linoleum or vinyl floor tiles
To Attach the Correct Accessory
.
Icon Description
Cone nozzle
50 mm Fish tail surface
nozzle
Make sure the on/off switch (a) is in position O and the tool is disconnected from the power source. Ensure the
1.
nozzle has cooled down.

P lace the desired accessory onto the nozzle.
2.
NU-E.2015_0216.indd 7
Purpose
Shrink sleeving (heat over concentrated small area)
Drying, removing paint, removing vinyl or linoleum, thawing (heat
spread over wide area)
1
E G B D
A
D
C
F
2/19/2016 3:07:29 PM