Horizon Hobby Hangar 9 Ultra Stick 30cc Manuel D'utilisation page 16

10. Use clamps to hold the stabilizer in position. Allow the
epoxy to fully cure before proceeding.
 FIN INSTALLATION
1. Fit the fi n into the slot in the fuselage. Use a ruler to
check the alignment of the fi n to the rear edge of the
fuselage.
2. Use a felt-tipped pen to trace the outline of the fi n on the
top of the fuselage. Also mark the bottom of the fi n along
the fuselage.
3. Use a hobby knife with a #11 blade to carefully remove
the covering 1/8-inch (3mm) inside the lines drawn from
the top of the fuselage at the rear of the fi n.
4. Use a hobby knife with a #11 blade to carefully remove
the covering 1/8-inch (3mm) inside the lines drawn from
the top of the fuselage at the front of the fi n.
EN
10.
1.
2.
3.
4.
5. Use a ruler and carefully cut the covering 1/8 inch (3
mm) below the line drawn on the fi n. Remove the bottom
covering. Use care not to cut into the underlying wood,
weakening the fi n.
6. Mix 1/2 ounce (15ml) of 30-minute epoxy. Use an epoxy
brush to apply the epoxy in the slot for the fi n and to the
exposed wood on the top of the fuselage.
7. Apply epoxy to the exposed wood on the bottom of the
fi n where it comes in contact with the fuselage.
8. Fit the fi n in position. Check that it is square to the
fuselage. Use tape if necessary to hold the fi n in position
until the epoxy fully cures.
 ELEVATOR INSTALLATION
1. Attach the control horns to the top of the elevators
following the same procedure as the aileron and fl ap
control horns.
16
5.
6.
7.
8.
1.