Horizon Hobby Hangar 9 Ultra Stick 30cc Manuel D'utilisation page 13

5. Thread an M3 x 15 self-tapping screw into each of the
holes in the aileron and fl ap servo cover mounting holes.
Remove the screws before proceeding.
6. Apply a small amount of thin CA to harden the threads
made in the previous step. Allow the CA to fully cure
before installing the aileron servo cover.
7. Install the grommets and brass eyelets in the servos.
Follow any instructions included with the servo. Prepare
both fl ap and aileron servos at this time.
8. Fit the servo between the servo mounting tabs in the
aileron servo tray. The servo arm will be centered in the
slot. Mark the locations for the servo mounting screws
using a pencil, then remove the servo.
9. Use a drill and a 1/16-inch (1.5mm) drill bit to drill the
holes for the servo mounting screws in the locations
marked in the previous step. Use a 2mm hex wrench to
thread a servo mounting screw into each of the holes in
the aileron servo mounting holes. Remove the screws,
then apply a small amount of thin CA to harden the
threads.
™
Ultra Stick 30cc
5.
6.
7.
8.
9.
10. Secure the servo to the cover using a 2mm hex wrench
and the screws provided with the servo.
11. Center the servo, then secure the servo arm so it is
perpendicular to the servo centerline.
12. Secure an 18-inch (460mm) servo extension to the
tip servo using a commercially available fastener
(SPMA3054).
13. Tie or tape the string located inside the wing to the end
of the servo lead.
14. Retrieve the servo lead at the wing root. Guide the lead
through the hole in the bottom of the wing.
13
10.
11.
12.
13.
14.
EN