Installation Instructions - Swann SWIFI-FLOCAM2W-EU Guide De Démarrage Rapide

INSTALLATION INSTRUCTIONS

This unit is designed to be mounted on a standard wiring junction box and requires
connection to a 100-240VAC power supply. For optimum results, install the unit at least
2.4m (8ft) above the ground.
Read "IMPORTANT SAFETY INSTRUCTIONS" and "PRE-INSTALLATION CHECK" and make
sure the installation site is Wi-Fi ready before installing the unit.
IMPORTANT! TURN POWER OFF AT CIRCUIT BREAKER OR FUSE BOX.
When installing the unit refer to the Installation Example Diagram on page 6.
1 If you're replacing an old floodlight, disassemble it along with any existing mounting
bracket from your junction box and disconnect the wire connections.
CAUTION:
Before handling any wiring, use a circuit tester to confirm that the power is
off.
2 Attach the provided mounting bracket to your junction box using the provided screws.
The side of the mounting bracket marked "GND" should be facing out.
3 Peel the backing off the adhesive foam gasket and stick it to the back of the floodlight
unit.
7
Englis h
EN